What the station does
Four load cells measure mass and centre of gravity, then four bolts lock the payload.
The rack stands on a short chain section that rests on four load cells, one under each corner. From the four values, the PLC computes mass and centre of gravity. It also finds a rack that rocks on three feet or something touching it.
Step by step
- The PLC sets the empty section to zero and weighs the empty rack.
- The vehicle pushes the payload in, slowly for the last 100 mm.
- The vehicle withdraws, and a light beam confirms the loading zone is clear.
- The scale settles for 2 s and averages the four corners for 3 s.
- Mass within 1 % and centre of gravity within ±100 mm pass the check.
- Four cylinders push the bolts in, and the rack tag gets its record.
Specifications
The devices
Each device is a real catalogue product. Its own product page will follow on the products level.
| Device | Role |
|---|---|
| Load cell, 1 t (x4) | Carries one corner of the weigh section. |
| Weighing terminal (x4) | Reads one load cell and reports its value. |
| Air cylinder (x4) | Drives one lashing bolt into the payload. |
| Air pressure sensor | Blocks lashing below 5 bar. |
| Radio tag reader and rack tag | Reads the rack number, writes the record. |
| Laser sensor and light beams | Payload at end stop, loading zone clear. |
Links lead to the makers' public product pages and are given for reference only. This site is independent work, not affiliated with, sponsored or endorsed by any manufacturer. The makers are responsible for the content of their pages. Trademarks belong to their owners.
The signals
| Signal | Direction | Meaning |
|---|---|---|
| Corner loads 1 to 4 | to PLC | Corner mass in kg from each terminal. |
| Payload at end stop | to PLC | The payload is fully in. Weighing may start. |
| Loading zone blocked | to PLC | Something crosses the loading side of the rack. |
| Lashing valves 1 to 4 | from PLC | Push the bolts up into the payload. |
| Air pressure | to PLC | Lashing starts only above 5 bar. |
| Rack record write | from PLC | Rack, payload, mass and centre of gravity. |
About this page
In the scenario, every rack that leaves 16 Psyche carries the mass and centre of gravity measured at this station.
Real devices, built from real data
Every machine and device in this twin is a real industrial product from the makers' catalogues. They range from sensors, valves and drives to safety scanners, load cells and RFID readers. Each model is built from the product's published data: dimensions, sensing ranges, signals, rated values, parameters and timing.
The PLC programs use the devices' real interfaces and parameters. Before any hardware existed, the twin found hundreds of faults in the plant design and the programs. So a real commissioning would need fine tuning, not a redesign.
